Catalogs FAQ



Difficulty Level
Share |
Natural Elegance™ Mother-of-Pearl White Flower Necklace and Earring Set

Instructions:

Necklace Materials:
3-White Mother-of-Pearl Flower Pendants BM11028
1 pkg-Black/Gray/Silver Beads BM10991
2-Silver Large Oval Jump Rings
12-Silver Crimp Beads
2-Silver 5 mm Jump Rings
1-Silver Lobster Clasp
1 yard-White Beading Thread
168 inches-Tiger Tail

Necklace Instructions:
1. Drill holes on bottoms of 2-White Flower Pendants.
2. Drill side and central holes on 3rd Flower Pendant.
NOTE: To drill holes, cover Flower Pendant with tape and make 2mm holes using hand drill.
3. Connect all 3-Flower Pendants using 2-silver large oval jump rings.
4. Prepare a needle with 1 yard of beading thread, then pass needle through central hole of 3rd Flower Pendant from back to front. String 6-Clear Seed Beads, 6-Gray Seed Beads, 6- Black Seed Beads, 1-Gray E Bead, 1-Black Seed Bead. Pass needle through all strung beads except last Black Seed Bead.
5. Pass needle through Flower Pendant and string 1-Clear E Bead. Pass needle over E Bead through Flower Pendant from back to front again.
6. Continue to create fringes as described, making them different lengths from 1 to 3 inches. Make 10 fringes total.
NOTE: Start every fringe using clear beads, with gray in middle and black on end.
7. Cut 32 inch tiger tail, then pass through side hole of Flower Pendant with fringes, placing flower in center. Pass both tiger tail ends through a crimp bead, then secure.
8. String Black, Gray & Silver Beads along 9½ inches of each end.
9. Attach both tiger tail ends to silver 5 mm jump ring using a crimp bead.
10. Repeat steps 7–9 two times.
11. Cut 24 inch tiger tail, then pass through top hole of other side Flower Pendant, placing flower in center. Pass both tiger tail ends through a crimp bead, then secure.
12. String Black, Gray & Silver Beads along 7 inches of each end.
13. Attach both tiger tail ends to silver 5 mm jump ring using a crimp bead.
14. Repeat steps 11–13 two times.
15. Attach lobster clasp to the ending 5mm jump rings.

Earring Materials:
2-White Mother-of-Pearl Flower Pendants BM11028
1 pkg-Black/Gray/Silver Beads BM10991
2-Silver 6 mm Jump Rings BM11148
2-Silver 4 mm Jump Rings BM11148
2-Silver Lever Back Earring Findings BM11117
12-Silver Head Pins BM11144

Earring Instructions:
1. Attach 6mm jump ring to hole in Flower Pendant.
2. Attach Flower Pendant 6mm jump ring to lever back earring finding using 4mm jump ring.
3. Create a dangle by sliding 1-Black Seed Bead, 1-Gray E Bead and 1-Black Seed Bead onto 1-head pin and forming a simple loop. Repeat 5 times.
4. Attach 3-dangles to 6mm jump ring, 2-dangles to 4mm jump ring and 1-dangle to lever back earring finding loop.
5. Repeat steps 1–4 to create 2nd earring.



PRODUCTS USED