Catalogs FAQ



Difficulty Level
Share |
Lost & Found™ Cameo Necklace and Bracelet

Instructions:

NECKLACE:

1.Cut 2-7 ½” pieces of Oval Link Chain.

2.Attach the Oxidized Silver Lobster Clasp to one end of each piece of chain by opening and closing the last link of the chain using the jump ring technique.

3.Attach the other end of chain pieces to the Metal Connectors by opening and closing the last link of the chain using the jump ring technique.

4.Attach 1-Smoke Acrylic Connector to each of the Metal Connectors using 1-link of the Oval Link Chain as a jump ring.

5.Repeat Steps 3-4 three additional times.

6.Attach the final 2-Smoke Acrylic Connectors from Step 5 to 1-Metal Connector by opening and closing the loops on the Acrylic Connectors.

7.Attach the other side of the Metal Connector from Step 6 to the top loop of the Cameo Pendant using 1-link of the Oval Link Chain as a jump ring.

8.Attach 1-Framed Acrylic Tear Drop to the bottom loop of the Cameo Pendant with 1-5mm Jump Ring, using the jump ring technique.

BRACELET:

1.Attach 1-Metal Connector to the bar side of 1-Oxidized Silver Toggle Clasp with 1-link of the Oval Link Chain as a jump ring.

2.Continue to attach bracelet parts to each other using 1-link of Oval Link Chain as a jump ring in the following order: 1-Smoke Acrylic Wire Wrapped Bead, 1-Metal Connector, 1-Smoke Acrylic Wire Wrapped Bead, 1-Metal Connector, 1-Smoke Acrylic Wire Wrapped Bead and 1-Metal Connector.

3.Attach the last Metal Connector from Step 2 to the toggle side of 1-Oxidized Silver Toggle Claps using 1-link of Oval Link Chain as a jump ring.

4.Separate a 3-link piece from the Oval Link Chain.

5.Attach the chain piece to the loop of the Oxidized Silver Toggle Clasp by opening and closing the first link of the chain using the jump ring technique.

6.Attach 1-Framed Acrylic Tear Drop to the second link by opening and closing the chain link using the jump ring technique.

7.Attach 1-Metal Connector to the third and final link.

8.Remove the second loop of the Metal Connector by simply snipping it with metal cutters.



PRODUCTS USED